Page 7 - Rout2021

WEALDEN TOOL
TCT ROUTER BITS Quality products - quality service
COM PAN Y

POCKET CUTTERS

A range of two flute cutters with extra length shanks for deep grooving and mortising.
These long cutters need to be used with considerable care to avoid breakage. Take many
small passes when slotting. When mortising, plunge down all over the area of the mortice,
then clean out in stages down to the full depth. All cutters have reduced necks for
clearance, except T2125½ & T2126½, which do not need it.
N.B. It is very important that the shank of these long cutters is inserted fully into the collet.
The cutters may extend through the base of the routing machine even in the fully up
position.

Part No. A B C D E

T2110 6.35mm 15mm 1/4 70mm 20mm
T2111 6.35mm 15mm 1/4 85mm 25mm
T2113 – 8 8.00mm 15mm 8mm 80mm 30mm
T2120 1/2 10.00mm 20mm 1/2 100mm 35mm
T2121 1/2 12.00mm 25mm 1/2 120mm 60mm
T2122 1/2 12.70mm 25mm 1/2 120mm 40mm
T2125 1/2 16.00mm 25mm 1/2 120mm –
T2126 1/2 16.00mm 25mm 1/2 150mm –

BOTTOM TRIM CUTTER

A range of two flute cutters which have a continuous cutting edge across the bottom. This
ensures a clean cut on the bottom of grooves, rebates etc. These cutters will give a better
finish on the bottom of cuts than a straight flute cutter. They may also be used for cutting
larger size stair housings where a parallel groove is required.

Part No. A B C D
T2137 1/2 16.0mm 12mm 1/2 40mm
T2140 20.0mm 12mm 1/4 38mm
T2143 25.0mm 12mm 1/4 38mm
T2144 – 8 25.0mm 12mm 8mm 38mm
T2145 1/2 25.0mm 12mm 1/2 40mm
T2147 – 8 35.0mm 15mm 8mm 38mm
T2148 1/2 35.0mm 15mm 1/2 40mm

TAPER 2 FLUTE – SPLINE

A straight 2 flute cutter with 5° taper making it suitable for
machining tapered components for moulding tooling etc. A further
use for this cutter is in boat repairs where it can be used for spline
cutting when replacing caulking with a timber insert.

Part No. A B C D E°
T4643 6.0mm 27mm 1/4 38mm 5°
T4644 – 8 6.0mm 27mm 8mm 38mm 5°
T4645 1/2 6.0mm 36mm 1/2 38mm 5°

Orderline 01580 890500 5 Fax orders 01580 890222