This tungsten carbide tipped shim adjustable grooving cutter wil cut grooves from 6mm to 10.5mm wide with a maximum cut depth of 13mm.
The cutter may be used in place of the groover on the frame jointing sets, thus allowing for infill panel thickness between 6mm and 10.5mm.
If used with the frame jointing sets only the cutters plus shims are required, as the arbor from the set may be used. It is also available as a complete assembly including an arbor.
Guide bearings should be selected from this table and then ordered from the Bearings and Spares section of the catalogue.Go to Bearings pageX