APPLICATION DETAILS:
As with all profile
cutters producing a wide moulded face, best results will be achieved by taking a small final cut of between 0.5mm - 1.0mm. This allows a constant feed rate to be achieved, thus overcoming the problems of poor surface finish due to overfeeding or burning due to a low feed rate.
These
cutters are designed to produce cornice mouldings from stock that is nominally 52mm x 22mm although other sizes may be used to suit particular requirements. The chamfer on the cornice may be produced after the face is moulded, either on the sawbench or with the use of a chamfer cutter such as T916B½.
X