This large diameter heavy duty rebate cutter may be used with guide bearings to produce rebates up to 26mm in width on straight or curved work. If used without a bearing, wide rebates may be produced by multiple passes. Guide bearings are supplied separately and should be selected from the table depending on the rebate width (A) required.
This is a large cutter and needs to be used at reduced speed - maximum 16,000 rpm.
CUTTERS SUPPLIED WITHOUT BEARINGS - ORDER BEARINGS AS REQUIRED.
Optional bearings should be selected
from this table and then ordered
from the Bearings and Spares section
of the catalogue.
PLEASE NOTE: bearings from the smaller
rebate cutters T1704 and T1714 series will not
fit on this cutter as they use a different centre bore size.Go to Bearings pageX