This range of rabbeting cutters may be used with or without guide bearings. If used without a bearing, wide rebates may be produced by multiple passes. Guide bearings are supplied separately and should be selected from the table (click Bearings selector) depending on the rebate width (A) required. The down-shear cutter is especially suited to fine work requiring a clean finish on the top face (i.e. guitar banding etc.).
CUTTERS SUPPLIED WITHOUT BEARINGS - ORDER BEARINGS AS REQUIRED.
Optional bearings should be selected
from this table and then ordered
from the Bearings and Spares section
of the catalogue.Go to Bearings pageX